Part Number TX7130

Standard

Listed LPCB Certification

Compliance EN 54-12:2015

Fire Detection and Alarm Systems BS 5839 Part 1:2017

Specification

Operating Voltage 20 V to 28 V DC

Current Parameters Standby: 23mA Commission: 56mA Alarm: 33mA

Beam Sensor Sensitivity [via Encoder] L e v e l 1 : 2 . 6 d B H ig h S e n s it iv i ty

Level 2: 3.8 dB Medium Sensitivity

Level 3: 5.8 dB Low Sensitivity

Beam Pathway Length [via Encoder]

Span 1: 8 to 20 meters Limited Path

Span 2: 20 to 40 meters Short Path

Span 3: 40 to 70 meters Normal Path

Span 4: 70 to 100 meters Long Path

Beam Path Angle ±0.4º Directional (This data takes the average of the left

and right deflection angles.)

Alignment Guide Laser Beam Pointer

Digital Display Guide Nixie Tube

LED Indicator Guide Red: Fire ; Yellow: Fault ; Green: Alignment

Reset Time Less than 2 Second

Relay Capacity [Fire & Fault] Normally Open & Close/ 2.0 A; 30 VDC

Physical

Material / Colour ABS / White

Dimension / Weight L:190.87 x W:126.87 x H:91.96 mm / 440 gm

Weight 0.130 Kg with base

Environmental

Operating Temperature -10°C to +50°C

Ingress Protection Rating IP30 [IP66 glue seal-For permanent fixing, Not EN54-12

approved]

Humidity 0 to 95% Relative Humidity, Non condensing

Programming Sensitivity and Span

Before using the detector, the operation range and sensitivity should be set according to the

application environment. It is can be set in two ways, one is through the inner DIP switch, and the

othrer is through the handheld programmer, which needs to be purchased separately

深圳市众安科电子有限公司