1. DESCRIPTION
The gas alarm is designed for single station use. Small and
compact, the design and color makes it ideal for use in the
home, small commercial properties, and recreational vehicles.
It is intended to detect leakage of natural gas (methane
gas), town gas, and bottled gas (propane gas). The unit
is designed for DC wire-in applications. The gas alarm
can be mounted high (for methane gas) or low (for
propane (LPG) gas). It is equipped with a sturdy metal
mounting bracket for quick, easy, and secure
installation.
2. FEATURES
?? Detect all sorts of combustible gases, natural gas
(methane), bottled gas (propane), LPG (Liquefied
petroleum Gas), LNG (Liquefied natural gas), coal
gas, including town gas.
?? Easy to install, mounting bracket included.
?? Loud 75dB alarm and LED warning light.
?? High quality durable sensor.
?? Self diagnostic function by MCU intelligent
software.
?? Excellent reliability & High stability.
?? Ideal for all kitchens.
3. TECHNICAL SPECIFICATIONS
Unit Dimensions: 103mm (D) x 55 mm (H)
Color: Ceiling White
Weight: 155g
Operating Temperature: -10°C to +50°C
Ambient Humidity: ≤95% RH
Alarm Horn: 75dB at 3m (10 feet)
Operating Voltage: DC9-28V
Power Consumption: <2W (Standby), <5W (Alarm)
Value of Detection Threshold (Lower Explosive Limit):
Natural Gas: 5000ppm (10% LEL)
Method of Alarm: Flashing Red LED with 75dB alarm
Warm Up Time: approximately 120 seconds
Alarm Output: Relay Output (Normal Open 2A@DC24V)
4. INSTALLATION INSTRUCTIONS
The Gas Alarm is intended to detect leakage of natural
gas, town gas and bottled gas. It is intended for
installation in the home, small commercial properties,
and recreational vehicles.
?? Installation shall only be undertaken by technicians
holding a certificate issued by an authorized
distributor.
?? For detecting natural gas (lighter than air), the
alarm should be installed within 30 centimeters
below the ceiling and the maximum distance away
from the furnace or gas appliances is 8 meters.
?? For detecting LPG (heavier than air), the alarm
should be installed within 30 centimeters above the
floor and the maximum distance away from the
furnace or gas appliances is 4 meters.
?? The alarm should not be located close to any
obstacles preventing natural air circulation. It
should also not be located in a draft or close to a
cooker (cooking smells and other fumes can have a
bad influence on gas detection).
?? The detector can be connected with Security alarm
panel as Figure1. Relay output signal can be
changed from Normal Close(NC) to Normal
Open(NO) by Jump JP1 on the PCB board.
?? The detector can be connected with conventional
alarm panel

深圳市众安科电子有限公司